The KATO AC Electric Driver was specifically designed to be a low cost alternative to the other electric drivers in KATO's electric tooling line. This driver is very lightweight and portable, and it does not require an Electric Transformer. The plug goes directly into any standard, U.S. wall outlet.

The driver runs at around 1,000 rpm's, which means that it is not suitable for unified sizes 2-56 and 4-40, as well as metric sizes M2.5 and M3. However, the driver is very easy to set and use, is extremely portable, and best-of-all, provides a very cost-effective electric tool solution.

 


Electric Driver

Hex Shank Installation Tool"5" align="center">

 
The electric tool consist of two major components:

1. The quick disconnect keyless chuck AC electric driver.
2. The Hex Shank installation mandrel.

Special Notes:

• Both components are required to install helically coiled inserts with the AC electric tool.
• Each thread size will require a different installation mandrel (see table below).
• The Tangless 2CTSB series of installation tools can be used for both manual and electric installation.  For hand installation snap the mandrel into the (optional) ergonomically designed handle.
• Kato strongly recommends Prewinder type tools for UNF (fine) and Metric thread sizes.

*Check with factory for availability.

Notes:  

• Kato recommends prewinder tools for UNF thread sizes.
• For the optional Handle add an H at the end of the Installation Tool part number.
• For the optional Wrenches (sold in pairs) add a W at the end of the Installation Tool part number.
• The "L" suffix on metric tools designates tool is for locking inserts only.
• The "F" suffix on metric tools designates tool is for free-running inserts only.

For additional technical data on KATO Electric Tools click here.