-
Adjust the
stop collar for the insert length
and installation depth.
Locate the collar on the mandrel so as to contact the body of
the prewinder when the mandrel projects a distance equal to
(approximately) the insert length plus 1/2 pitch.
-
Pull the
mandrel to the back of the prewinder and place the insert into this
well. There is no need
to orient the insert, tangless inserts are bi-directional.
-
Rotate the
mandrel until the pawl engages the insert notch.
Continue to rotate mandrel until the insert projects beyond
the tool tip 1-2 turns.
-
Place the
tool against the tapped hole and rotate the mandrel until the stop
collar contacts the body of the prewinder.
-
Retract the
mandrel. Check
installation for proper depth and readjust the stop collar if
necessary.
PAWL
REPLACEMENT:
Follow
the procedures below to replace a worn or broken pawl.
-
Loosen the
round lock nut from the prewinder sleeve.
-
Slide the prewinder sleeve off the
threaded mandrel.
-
Push out the cross pin, be careful
not to lose the pin.
-
Remove
the pawl from the mandrel slot, be careful not to lose the spring.
-
Insert the replacement pawl into
the mandrel slot.
-
Line up the holes and press in the
cross pin.
-
Check for spring action and free
movement of the pawl in the mandrel slot.
-
Thread
the lock nut and adjusting sleeve back onto the mandrel.
For additional assistance contact the KATOŽ Tech-Group at
757-873-8980, or e-mail us at
tech-group@katonet.com.
Protect Your
Vision: Wear safety glasses when using KATOŽ Inserts and Tools.
|
